Duck Tape shared the step by step instructions for creating dad a cool wallet. Go here to see the post: http://bit.ly/LwSF21
Directions
Step 1
Make a duct tape sheet that is 7 inches long by four strips wide:
· Cut a strip of duct tape that measures 7 inches and lay it sticky side up on your work surface.
· Roll out and cut another strip of duct tape to the same length.
· Place the second 7-inch strip sticky side up so it slightly overlaps the edge of the first strip.
· Repeat until you have four strips overlapping.
· Turn the sheet so the strips run vertically.
· Cut a strip to lay across the sticky-side-up strips. Start at the top and work your way down. These strips get placed sticky side down. Add another strip below the last one. Remember to overlap the edges.
· Continue laying strips sticky side down until all of the sticky sides of the "bottom" strips are covered.
· Trim off edges.
Step 2
Fold the sheet in half so you have a rectangle.
Step 3
Use a piece of tape about 4 inches long to seal the edge on one of the short sides of the rectangle. Trim off the extra tape.
Step 4
Fold the wallet in half so the short sides line up. Note: Do this before taping the other side so that the wallet will fold without bulges.
Step 5
Keep the wallet in the folded position, trim any excess, and tape the other side.
Options
Personalize the wallet with initials, favorite colors, or a personal trademark (such as a fish if Dad loves fishing or use Camouflage Duck Tape® for the Dad who's a hunter).
* Adapted with permission from Got Tape? Roll Out the Fun With Duct Tape!, by Ellie Schiedermayer, published by Krause Publications, Iola, WI, www.krausebooks.com , phone: 800-258-0929.